Icom IC-905 - Page 135

11
D-STAR OPERATION (ADVANCED)
11-3
“FROM” (Access repeater) setting
When your access repeater is in your transceiver’s
repeater list, you can select it from the list. By just
selecting the repeater from the list, the repeater call
sign, its frequency, duplex setting, and frequency
o󰀨set are automatically set, for easy operation.
Example: Selecting the “Kirkland” repeater in
Washington state in the USA from the
repeater list.
1. Hold down
for 1 second to display the DR
screen.
2. Touch “FROM” to select, and then touch “FROM”
again.
3. Touch “Repeater List.”
• Displays the REPEATER GROUP screen.
4. Touch the repeater group where your access
repeater is listed.
5. Touch your access repeater. (Example: Kirkland)
• Returns to the DR screen, and the selected repeater
name is displayed in “FROM.”
L See page 10-6 “IMPORTANT!” about the node
letters.
L By just selecting the repeater name, the repeater
call sign, its frequency, duplex setting, and frequency
o󰀨set are automatically set.
TIP:
When you select an FM repeater:
When an FM repeater is in your transceiver’s
repeater list, you can select it from the list.
When selecting an FM repeater, the “TO” setting is
not necessary, and a “---” is displayed in “TO.”
When selecting an FM repeater.
How to change the repeater group:
To change the repeater group on the DR screen,
push , then touch “Group Select.”
D Using your transceiver’s repeater list