Icom IC-905 - Message operation

11
D-STAR OPERATION (ADVANCED)
11-12
Message operation
You can save up to 5 short messages in the
transceiver’s memory to transmit in the DV mode.
Each message can contain up to 20 characters.
D Entering a TX message
Example: Entering “JAPAN TOM” into TX message
memory number 1.
1. Open the TX MESSAGE (DV) screen.
»
SET > My Station > TX Message (DV)
2. Touch a TX message memory number for 1
second.
3. Touch “Edit.”
4. Enter a message of up to 20 characters, then
touch [ENT].
5. To close the TX MESSAGE screen, push .
D Transmitting a message
You can transmit a preset TX message by pushing
[PTT] in the DV mode. First, select a TX message
which also turns ON the Message Transmission
function.
1. Open the TX MESSAGE (DV) screen.
»
SET > My Station > TX Message (DV)
2. Touch a TX message memory number.
L To not transmit any message, touch “OFF.”
3. To close the TX MESSAGE screen, push .
L Information
• The message is transmitted along with your voice signal.
• The message is transmitted each time you transmit.
• When continuously transmitting, the selected TX
message is transmitted every 30 seconds.
D Deleting a TX message
You can delete the TX messages.
Example: Deleting TX message “JAPAN TOM” from
TX message memory number 1.
1. Open the TX MESSAGE (DV) screen.
»
SET > My Station > TX Message (DV)
2. Touch a TX message memory number for 1
second.
3. Touch “Clear.”
• The conrmation dialog is displayed.
4. Touch [YES].
• Clears the entered message.
5. To close the TX MESSAGE screen, push .