Icom IC-905 - Page 177

12
ABOUT THE DV GATEWAY FUNCTION
12-8
Setting up a network
3. Port forwarding
When using a router, enable communication with the Internet, as described below�
• Forward the port number 40000 to the transceiver, Windows, or Android device�
• “UDP” should be used as the port protocol�
• Set a static local IP address in Procedure 2 (2� Setting a static local IP address) as a destination port�
L Check the router’s manual about how to forward the port�
L Only one transceiver, Windows, or Android device connected to the router can use the DV Gateway function at the same
time�
L Depending on the router settings, you must congure the IP lter settings. Check the router’s manual on how to congure the
settings�
 When using the Internal Gateway function, go to “Setting up the transceiver�” (p� 12-11)
 When using a Windows device, go to “Setting up the RS-MS3W�” (p� 12-13)
 When using an Android device, go to “Setting up the RS-MS3A�” (p� 12-14)
*
1
A static IP address to the transceiver, Windows, or
Android device is recommended�
*
2
Needs a Global IP address and forwarding port number
40000�
D When connecting your device to the Internet using a router
INTERNETINTERNET
USB cable
USB cable
*
1
*
1
*
1
*
2
*
2
*
2