14
MAINTENANCE (ADVANCED)
14-3
Cloning
Step 3. Loading the setting data into the sub
transceiver.
1� Open the LOAD SETTING screen�
»
SET > SD Card > Load Setting
2� Touch the file to load�
3� Touch “Select�”
LIf you want to load all the contents on the LOAD OPTION
screen, touch “ALL” and go to step 6�
LIf you want to load only the repeater list, touch “Repeater List
Only” and go to step 6�
4� Touch the loading options�
(Example: CI-V Address)
• “✓” is displayed on the left side of the selected option�
L The Set mode settings and Memory channel contents
are always loaded�
5� Touch “<<Load>>�”
6� Touch [YES] or [NO]�
L When you touch [YES], the skip settings of the
repeater list are retained�
L When you touch [NO], the skip settings of the
repeater list are cleared�
7� Touch [YES]�
L After the loading ends, “COMPLETED! Restart the
IC-905�” is displayed�
L When you select “REF Adjust” in step 4, “The new
“REF Adjust” setting will be saved” is displayed�
8� Turn OFF the transceiver, then turn it ON again to
restart the transceiver�
To Next Page
Loading...
