Icom IC-905 - Page 212

15
UPDATING THE FIRMWARE
15-5
Updating the firmware
Updating the CX-10G’s rmware
CAUTION: NEVER turn OFF either the transceiver,
or NEVER disconnect the cables while updating
the rmware. If you turn OFF the transceiver, or
disconnect the cables, or if a power failure occurs
while updating, the transverter’s rmware may
be damaged, and you may have to send the
transverter’s back to the nearest Icom distributor for
repair. This type of repair is out of warranty, even if
the transverter warranty period is still valid.
1� Access the following URL and download the
firmware file.
https://www.icomjapan.com/support/
2� Unzip the downloaded firmware folder.
3� Copy the firmware data into the “IC-905” > “CX-10G”
folder on to an SD card.
4� Insert the SD card into the transceiver.
5� Display the FIRMWARE UPDATE (CX-10G) screen.
»
SET > SD Card >
Firmware Update (CX-10G)
6� After you read and agree with all the precautions,
touch [YES].
• Scroll the screen and read all the precautions.
7� Touch the Firmware.
• The nal conrmation screen is displayed.
L Carefully read all the displayed precautions.
8� After you read and agree with all the precautions,
touch [YES] for 1 second.
• The updating starts.
9� When the update is completed, “Firmware
updating has completed.” is displayed in the
dialog�
• The transceiver will automatically restart.