Why is transmitting impossible on my Icom Transceiver?
If transmitting is impossible on your Icom Transceiver, it could be due to a couple of reasons. The batteries might be exhausted, so try replacing them or charging the battery pack. Alternatively, you may have set a frequency outside of the 144/440 MHz amateur bands. Reset the frequency to within the 144/440 MHz amateur bands.
What to do if no sound comes from the Icom Transceiver speaker?
If you're not getting any sound from the speaker of your Icom Transceiver, there are a couple of things to check. First, the volume level might be too low. Rotate the [VOL] knob to a suitable level. Second, if you have an external speaker connected with OPC-1797, verify that the connection of the external speaker or OPC-1797 is correct.
Why can't I contact another station with my Icom Transceiver?
If you are unable to contact another station using your Icom Transceiver, it might be because a different tone is selected with tone/DTCS squelch. Check the tone/DTCS using tone scan.
What causes an erroneous frequency display on an Icom Transceiver?
If the displayed frequency on your Icom Transceiver is incorrect, it could be due to two reasons: The CPU may have malfunctioned; try resetting the transceiver. Alternatively, external factors might have caused a fault; remove and re-attach the battery pack or battery case.
What prevents the memory scan function from starting on my Icom Transceiver?
If the memory scan function will not start on your Icom Transceiver, it could be due to a couple of reasons: VFO mode or call channel is selected, so push [MR] to set memory mode. Also, if the programmed memory channel is only one, program more than 2 memory channels.
Why does the BC-177 LED blink orange when charging my Icom Transceiver battery?
If you can't charge the battery with BC-177 and the LED blinks orange, it may be because the transceiver's power is ON. Turn the transceiver’s power OFF, or insert only the battery pack into the BC-177 to charge it. Another reason might be that the battery pack has fault electric discharge. The battery pack is charged alone (without the trans- ceiver) or regular charge is carried out.
General| Frequency Range | 144-148 MHz, 430-450 MHz |
|---|---|
| IP Rating | IP54 |
| Waterproof | Yes |
| GPS | Yes |
| Bluetooth | No |
| Modulation | FM, AM |
| Receiver Sensitivity | 0.16 μV (12 dB SINAD) |
| Operating Voltage | 7.4V DC |
To Next Page
