EasyManua.ls Logo

Icom IC-PW2 - Page 59

Icom IC-PW2
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...

9
9

Troubleshooting
Problem Possible cause Solution REF.
Even if an exciter starts

does not transmit or output
power.

there is a bad connection with the cable.
• Connect the cable to an exciter.
• Check the cable.

The accessory cable is not connected,
or there is a bad connection with the
cable.
• 

• Check the terminals of the cable.
pp.



there is a bad connection with the cable.
• Connect the cable to [SEND 1] or

• Check the cable.
pp.


The RX side RF input connector

Change the TX/RX side RF input
 

  p. 3-3
The protection circuit is activated. Find and repair the cause of the
problem, and then push
PROTECT
to
deactivate the protection circuit.

The output power is too low. 

connected.
Connect an exciter with a maximum






–

output power.
Transmit at maximum transmit output
power.
–
 Switch to the output power to be used

p. 3-3
The antenna SWR is too high. • 

band to transmit.
• Turn ON the internal antenna tuner.

4-1,
5-1
  p. 4-1
The DPD function does not
work.

the function, or a non-Icom exciter is
connected.
Connect an Icom exciter that supports
the function. –

the function.

–

possible.

 is not connected to

• 

• Check the terminals of the cable.

  p. 3-3
 
a dummy load, perform the DPD

–

alone is not completed.

for an Icom exciter alone, perform


–
The antenna SWR is too high. Check the cables used to connect

antenna SWR to less than 1.5:1.

Even if
TUNER
is held down
for 1 second, an Icom exciter
does not start transmitting for
linked manual tuning.

version.

supports linked manual tuning.


Table of Contents