Icom IC-R8600 - Mode Select Memory Scan and Skip Frequency

9
SCANS
9-9
Mode select memory scan Setting the skip frequency
Repeatedly scans the selected receive mode (ignoring
other modes) while memory scanning, except
Programed Scan Edge channels (P00A/P49A ~ P00B/
P49B)
.
D Setting the receive mode
1. Select the receive mode.
2. Open the SCAN screen.
MENU
» SCAN
3. Touch [TYPE/SET].
4. Touch [MODE].
5. Touch [SELECT] to select the item, then rotate
to change the setting.
• Set the channel group and edge channels.
LYou cannot change the receive mode on this screen.
6. Touch [SELECT] several times to exit the edit
mode, then touch [START].
• The mode select memory scan starts.
L “MODE SELECT MEMORY SCAN” and decimal
points blink while scanning.
• Touch [STOP] to cancel the scan.
7. To close the SCAN screen, push
EXIT
.
You can set a frequency as a skip frequency that is
skipped (ignored) during a VFO scan*.
* Programmed scan, Fine Programmed scan, Auto Write Memory
scan, ∂F scan and Fine ∂F scan
D Setting the skip frequency
z Hold down for 1 second while a signal is
received and the scan is paused.
• The frequency is stored as the Scan Skip channel (S00
~ S99).
L The “PSKIP (Program SKIP)” is displayed on the skip
channel.
LDuring a VFO scan, the skip frequency is not skipped.
D Canceling the skip frequency
1. Touch the memory channel number.
2. Touch [SKIP].
L Each touch changes between “SKIP,” “PSKIP” and
“(no icon).”
L"PSKIP" disappears and the skip setting is cancelled.
3. To close the VFO/MEMORY screen, push
EXIT
.
SCAN screen
Blinks
Deactivated
during a Memory
scan
VFO/MEMORY screen
99chWFM WFM
00ch
01ch 02ch 03ch
WFM
AM WFM WFM
WFM
AM AM WFM
04ch
05ch06ch50ch98ch
(Example) Group: ALL (Each channel is in the different group.)
All modes except the
WFM are skipped.