Icom IC-R8600 - SET MODE (Continued); Time Set and SD Card Operations Management; Firmware Update and Other Settings

11-10
Time Set
Date/Time > Date (Default: 2000/01/01)
Sets the date* (Year/Month/Day).
• Settable range: 2000/01/01 ~ 2099/12/31
LThe day of the week is automatically set.
L If the NTP Function is ON and receiver is connected to
Internet, these items are automatically set.
Date/Time >
Time (Default: 0:00)
Sets the current time.
• Settable range: 0:00 ~ 23:59
LThe time is displayed in the 24 hour format.
L If the NTP Function is ON and receiver is connected to
Internet, these items are automatically set.
Date/Time >
<<NTP TIME SYNC>>
Touch to synchronize the internal clock to the NTP server.
• Automatically obtains the current time from the NTP server.
Date/Time >
NTP Function (Default: ON)
Automatically obtains the current time from the NTP server.
• OFF: Turn OFF the function.
• ON: Use the function. (An internet access is necessary.)
Date/Time > NTP Server Address (Default: time.nist.gov)
Sets the NTP server address.
LDo not change this setting, unless it is necessary.
LRefer to page 1-7 for the character entering.
UTC Offset (Default: + 0:00)
Sets the UTC offset time.
• Range: –14:00 to +14:00 (in 5 minute steps)
SD Card
Load Setting
Selects the saved data le to load.
L See “Using An SD Card” in Section 7 for data load details.
Save Setting
Saves the setting data onto an SD card.
L See “Using An SD Card” in Section 7 for data write details.
SD Card Info
Displays the SD card capacity and the time remaining
for recording.
Screen Capture View
Displays the selected screen capture.
L See “Screen Capture function” (p. 5-11) for details.
Firmware Update
Enters the Firmware Update mode.
L See “Updating the rmware” (p. 13-1) for details.
Format
Formats the SD card.
L See “Formatting an SD card” (p. 7-2) for details.
Unmount
Unmounts the SD card.
SD Card (Continued)
Others
Information > Version
Displays the rmware version.
Clone > Clone Mode
Touch to enter the cloning mode.
L The cloning mode is cancelled on restart.
Touch Screen Calibration
Touch to adjust the touch screen.
L Touch the white dots that sequentially appears on the screen.
<<BER Measurement Start/Stop>>
Touch to enter or quit the BER Measurement mode.
• “BER” is displayed while in the measurement mode.
•
Push to select the testing signal type (Clock/Data or
UART) and measurement mode (General or P25 specic).
Reset > Partial Reset
Touch to return all the settings to their factory defaults
except the memory channels.
L See “Resetting” (p. 12-2) for details.
Reset >
All Reset
Touch to return all the settings to their factory defaults,
and clears all the memory channels.
L See “Resetting” (p. 12-2) for details.
MENU
» SET > Time Set
MENU
» SET > Time Set
NOTE:
Before you remove a card when the receiver is ON,
be sure to electrically unmount it (p. 7-1). Otherwise
the data may be corrupted or deleted.
MENU
» SET > Other
11
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21