Icom IC-R8600 - Temporary Skip and Skip Channel Settings

9-10
You can set a selected memory channel as a Skip
channel (SKIP or PSKIP) which is skipped during a
memory scan.
L You cannot assign the Programed Scan Edge channels
(P00A/P49A ~ P00B/P49B) as skip channels.
1. Open the MEMORY screen.
MENU
» MEMORY
2. Rotate
and touch to select the memory
channel you want to set or clear the skip setting.
L Push or to change the group.
3. Push .
4. Touch [SKIP].
• The SKIP screen is displayed.
5. Touch the desired option.
• OFF: Clears the skip setting.
• SKIP: Skipped during a memory scan.
(Not skipped during a VFO scan.)
• PSKIP: Skipped during a VFO or memory scan.
• "SKIP" is displayed.
6. To close the MEMORY screen, push
EXIT
.
You can set a frequency as a temporary skip
frequency that is skipped (ignored) during a VFO
scan* or memory scan, for a period of time (default:
5 minutes).
* Programmed scan, Fine Programmed scan, Auto Write Memory
scan, ∂F scan and Fine ∂F scan.
1. Start a VFO or memory scan.
MENU
» MEMORY
2. Push
.
• The QUICK MENU is displayed.
3. While the scan is paused and if you want to skip
the received signal, touch [Temporary Skip].
L If you touch during scan, a beep sounds and the
QUICK MENU closes.
• The Temporary Skip is set, then the scan resumes.
Skip channel for memory scanSetting the Temporary Skip
MEMORY screen
TIP: About the Temporary Skip
• You can set up to 5 skip frequencies.
When you set the 6th frequency, the oldest
frequency will be deleted.
• The Temporary Skip is canceled when:
- The time that is set to the Temporary Skip Timer
item (p. 9-3) has passed.
- You turn OFF the receiver power.
- You cancel the scan.
QUICK MENU
9
SCANS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21