Icom IC-R8600 - Page 75

11-8
Network Name
When you remotely control the IC-R8600 using the
optional RS-R8600 (future product), enter a network
name.
L“.” (period) cannot be used for the rst character.
LPush
to change the keyboard type.
LRefer to page 1-7 for the character entering.
Network Control (Valid after Restart) (Default: OFF)
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), select “ON.”
• OFF: Turn OFF the function.
• ON: Turn ON the function.
LThis setting takes effect after restart.
Power OFF Setting (for Remote Control)
(Default: Shutdown only)
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), select “ON.”
• Shutdown only: Shuts down immediately.
• Standby/Shutdown: Displays the SHUTDOWN dia-
log before shutting down.
Control Port (UDP) (Valid after Restart)
(Default: 50001)
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), set a port number for
the control signal transfers between the IC-R8600 and
the remote station.
• Set the same port number to the PC.
LThis setting takes effect after restart.
Serial Port (UDP) (Valid after Restart)
(Default: 50002)
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), set a port number for
the serial data transfers between the IC-R8600 and the
remote station.
LThis setting takes effect after restart.
Audio Port (UDP) (Valid after Restart)
(Default: 50003)
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), set a port number for
the audio signal transfers between the IC-R8600 and
the remote station.
LThis setting takes effect after restart.
Network (Continued)
Internet Access Line (Valid after Restart )
(Default: FTTH)
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), set the port number
for the audio signal transfers between the IC-R8600
and the remote station.
• Set the same port number to the remote station.
LThis setting takes effect after restart.
Network user1 >
Network User1 ID
Network user2 > Network User2 ID
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), enter a user name.
LPush to change the keyboard type.
LRefer to page 1-7 for the character entering.
Network user1 >
Network User1 Password
Network user2 > Network User2 Password
Enter a password for each user.
LPush to change the keyboard type.
LRefer to page 1-7 for the character entering.
Network user1 >
Network User1 Administrator
Network user2 > Network User2 Administrator
(Default: NO)
Sets the user as the administrator.
Only authorized users can disconnect the communi-
cation between the remote IC-R8600 and the optional
RS-R8600 (future product).
• NO: Not authorized.
• YES: Authorized.
Network Radio Name
(Default: IC-R8600)
When you remotely control the IC-R8600 using the op-
tional RS-R8600 (future product), enter a nickname.
LPush to change the keyboard type.
LRefer to page 1-7 for the character entering.
11
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21