Icom IC-T70A - Entering Frequencies Using the Keypad

New2001
D Using the keypad
The frequency can be directly set using the nu-
meric keys.
•Ifafrequencyoutsidethetransceiver’sfrequency
range is entered, the previously displayed fre-
quency is automatically recalled after entering the
last digit.
q Push [V/M/C] to select the VFO mode, if any
other mode is selected.
w Enter the desired frequency with the keypad.
20
4
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Depending on the
tuning step setting, it
may not be possible to
input a 1 kHz digit. In
this case, enter “0” as
a 1 kHz digit, then ro-
tate [DIAL] to set the
desired frequency.
• Entering 145.500 MHz
• Changing 100 kHz and below
Editing 145.500 MHz to 145.640 MHz
Push to cancel numeral key input.
• Changing 10 MHz and below
Editing 445.560 MHz to 432.380 MHz
• Changing 1 MHz and below
Editing 145.500 MHz to 144.640 MHz