Icom IC-T70A - Displaying Memory;Bank Name Indication

New2001
35
6
MEMORY/CALL CHANNELS
New2001
■ Programming memory/bank/scan name (continued)
[EXAMPLE]: Programming the bank name “VHF” into the
scan edge channel 1A
■ Selecting memory/bank
name indication
During memory mode operation, either the programmed
memory name or bank name can be displayed.
q While continuing to push [SET], turn the power ON to
enter the Initial set mode.
w Rotate [DIAL] to select the memory name item, then rotate
[VOL] to set the memory name display option.
 •“OFF” :MemorynamedisplayisturnedOFF.
 •“On”  :TurnsONthememorynamedisplay.(default)
[VOL]
[DIAL]
Memory name setting
e Push [ ] to return to the frequency display.
Push and hold
for 1 sec.
Push and hold
for 1 sec.
Enter the select memory
write mode.
Push repeatedly
to select “b nAmE*
2
.”
Push and hold
for 1 sec. to program.
During memory mode, rotate
to select scan edge channel 1A.
Rotate to select “V,”
then push .
Select “H” and “F”
with and .
*
1
S nAmE can be set for scan edge channels only.
*
2
b nAmE can be set for bank assigned channels only.
Select “m nAmE” or “S nAmE*
1
”
when programming the memory
name or the scan name, respectively.