Icom IC-T70A - Checking Repeater Input Signal and Off-Band Indication

New2001
25
5
REPEATER AND DUPLEX OPERATIONS
New2001
D Checking the repeater input signal
The transceiver can check whether the other station’s trans-
mit signal can be received directly or not, by listening on the
repeater input frequency.
➥ Push and hold [MONI](BAND) to check whether the other
station’s transmit signal can be received directly or not.
 •Whentheotherstation’ssignalcanbedirectlyreceived,move
to a non-repeater frequency to use simplex. (duplex OFF)
Display while receiving
Receives –0.6 MHz lower
Blinks while pushing and holding [MONI]
Push and hold
D Off band indication
If the transmit frequency is out of the amateur band when
[PTT] is pushed, the off band indication, “OFF,” appears on
the display. Check the frequency offset or duplex direction in
that case.
(p. 26)
U.S.A. and Korean versions:
The auto repeater function uses standard values of the
frequency offset.
✔ CONVENIENT!
Tone scan function: When you don’t know the subaudible
tone used for a repeater, the tone scan is convenient for de-
tecting the tone frequency.
➥ Push and hold [T.SCAN](#) for 1 sec. to start the tone
scan. See p. 71 for more information.