Icom IC-T70A - Tuning Step, Duplex, Mode, and Weather Alert Settings

New2001
54
9
SET MODES
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
D Tuning step (TS)
Selects the tuning step between 5, 10, 12.5, 15, 20, 25, 30,
50, 100, 125 and 200 kHz for the dial operation.
5.0 kHz tuning step
The default value may differ, depending on the selected fre-
quency band (before accessing the Set mode) and the trans-
ceiver version.
D Frequency offset (OFFSET)
Sets the frequency offset for duplex operation (repeater)
within the range of 0 to 59.995 MHz.
0.600 MHz setting
The default value may differ, depending on the selected fre-
quency band (before accessing the Set mode) and trans-
ceiver version.
The selected tuning step in the VFO mode is used when
setting the frequency offset.
D Reverse duplex function (DUP.REV)
Turns the reverse duplex function ON or OFF. (default: OFF)
Reverse function is OFF
D Operating mode (MODE)
Sets the operating mode between “WIdE” (FM mode) and
“nARROW” (FM-N mode). (default: WIdE)
FM mode setting
U.S.A. version only
D Weather alert (WX.ALT)
Turns the weather alert function ON or OFF. (p. 72)
(default: OFF)