Icom IC-T70A - Auto Repeater Function Configuration

New2001
27
5
REPEATER AND DUPLEX OPERATIONS
New2001
■ Auto repeater function
The U.S.A. and Korean versions automatically use standard
repeater settings
(duplex ON/OFF, duplex direction, tone encoder
ON/OFF) when the operating frequency falls within or outside
of the general repeater output frequency range. The offset
and repeater tone frequencies are not changed by the auto
repeater function. Reset these frequencies, if necessary.
D Frequency range and offset direction
• U.S.A. version
• Korean version
FREQUENCY RANGE SHIFT DIRECTION
439.000–440.000 MHz “DUP–” appears
q While continuing to push [SET], turn the power ON to
enter the Initial set mode.
w Rotate [DIAL] to select the auto repeater set item, then
rotate [VOL] to set the auto repeater setting.
U.S.A. version:
  •“R1”  :Activatesduplexonly.(default)
  •“R2”  :Activatesduplexandtone.
  •“OFF” :AutorepeaterfunctionisturnedOFF.
Korean version:
  •“On”  :Activatesduplexandtone.(default)
  •“OFF” :AutorepeaterfunctionisturnedOFF.
[VOL]
[DIAL]
U.S.A. version
Korean version
Auto repeater setting
e Push [ ] to return to the frequency display.
FREQUENCY RANGE SHIFT DIRECTION
147.000–147.395 MHz “DUP” appears
442.000–444.995 MHz “DUP” appears
447.000–449.995 MHz “DUP–” appears
145.200–145.495 MHz
146.610–146.995 MHz
“DUP–” appears