Icom IC-T70A - Display Backlighting and Beep Output Level; Auto Repeater Function Settings

New2001
61
9
SET MODES
New2001
D Power save (P SAVE)
The power save function allows you conserve battery life by
selecting the duty cycle of the receiver. Select the ratio of the
power save time to the standby time. (default: Auto)
•OFF :TurnsthefunctionOFF.
•2 :Setsthedutycycleto1:2.
•8 :Setsthedutycycleto1:8.
•16 :Setsthedutycycleto1:16.
•32 :Setsthedutycycleto1:32.
•Auto :Transceiversets“1:2”dutyratiowhenreceivingno
signal for 5 seconds, then it sets “1:16” after 60 sec-
onds has past.
62.5 msec.
60 sec.
125 msec.
1000 msec.
No signal
5 sec.
Circuit ON
Circuit OFF
NOTE: Power save function is disabled when using an ex-
ternal power supply (more than 10 V DC).
D Voltage indication (VOLT)
The power voltage, battery voltage or external power supply
voltage, is displayed at power ON. This setting can be turned
ON or OFF. (default: On)
•OFF :Thepowervoltagedisplayisskipped.
•On :ThepowervoltageisdisplayedatpowerON.
D DTMF speed (DTMF-S)
Select the desired DTMF transmission speed from 100, 200,
300 or 500 msec. (default: 100)
•100 :100msec.interval;5.0characterspersecond
•200 :200msec.interval;2.5characterspersecond
•300 :300msec.interval;1.6characterspersecond
•500 :500msec.interval;1.0characterpersecond