Icom IC-T70A - Program Scan Link Setup and Naming

New2001
57
9
SET MODES
New2001
• Program scan link setting
q Rotate [VOL] to select the program scan link number that
you want to change.
w Push and hold [SET] for 1 sec. to enter the program scan
link setting.
• “LInk” appears.
e Rotate [DIAL] to select the option, “Add” or “CLEAR.”
r Push and hold [SET] for 1 sec., then rotate [DIAL] to
select the desired program scan
.
• When “Add” is selected in step e, only non-linked program
scans are displayed. When “CLEAR” is selected in step e, only
linked program scans are displayed.
t Push and hold [SET] for 1 sec. to set the program scan
link setting.
y Repeat steps r and t to add or clear the program scan
to or from the link, or push [BAND] to exit the program
link scan setting.
u After pushing [BAND], rotate [DIAL] to save the setting.
• Program scan link name programming
q Rotate [VOL] to select the program scan link number for
which you want to program a name.
w Push and hold [SET] for 1 sec. to enter the program scan
link setting.
• “LInk” appears.
e Rotate [DIAL] to select “nAmE.”
r Push and hold [SET] for 1 sec. to enter the name
programming.
t Rotate [DIAL] to select the desired character, number,
symbol or space; push [BAND] or [SET] to move the cur-
sor right or left, respectively.
y When the cursor is on the 6th digit, push [BAND] to pro-
gram the scan link name and exit the setting.
u Push [BAND] to exit the program link setting.
i Repeat steps from q to u to program the program link
scan name, or push [V/M/C] to exit the Set mode.