Icom ID-51A - Page 61

New2001
48
6
D-STAR OPERATION
6
Push D-pad( e ) to select “Re-
peater List,” and then push
D-pad(Ent).
Go to step y
Foryourreference:
You have four other ways to select your access repeater,
other than selecting it from repeater list. See the Advanced
Instructions for more details.
•Rotating[DIAL]
• Searching for the nearest repeaters
• Selecting from the TX History
• Searching for a repeater using the DR scan
Push D-pad( r ) to select the
repeater group where your
access repeater is listed, and
then push D-pad(Ent).
 •Example:“11:Japan”
Push D-pad( t ) to select your
access repeater, and then
push D-pad(Ent).
 •Example:“Hirano”
Repeater area
Repeater call sign
If the selected repeater name y
is displayed in “FROM” on the
DR screen, the access re-
peater setting is completed.
Completed
Completed
•Whenyouselectjusttherepeatername,therepeatercall
sign, its frequency, duplex setting, frequency offset and
Gateway call sign are automatically set.
•Therepeaterlist,describedinthismanual,maydifferfrom
your transceiver’s programmed list.
NOTE: See page 60 for status indications after a repeater
system reply is received.
D-STAR OPERATION