Inficon IC6

10 - 50
IPN 074-505-P1E
IC6 Operating Manual
11
(0x0b)
Zero Counter
<Counter>
<Byte> Counter Range is 0-20
0 = All
12
(0x0c)
Zero Timer
<Timer>
<Byte> Timer Range is 0-20
0 = All
13
(0x0d)
Start Timer
<Timer>
<Byte> Timer Range is 1-20
14
(0x0e)
Cancel Timer
<Timer>
<Byte> Timer Range is 0-20
0 = All
15
(0x0f)
Clock Hold On
<Material>
<Byte> Stops timer in Pre-Deposit or Post-Deposit. Keeps in
current state at current power setting.
Material Range 0-32 (0 = all materials)
16 (0x10) Clock Hold Off
<Material>
<Byte> Restarts timer in Pre-Deposit or Post-Deposit
Material Range 0-32 (0 = all materials)
17
(0x11)
User message on
<Message #>
<Byte> Message Range is 1-10
18
(0x12)
User message off
<Message #>
<Byte> Message Range is 1-10
19
(0x13)
Soak Hold 1 on
<Material>
<Byte> Material Range is 0-32
(0 = all materials)
20
(0x14)
Soak Hold 1 off
<Material>
<Byte> Material Range is 0-32
(0 = all materials)
21
(0x15)
Soak Hold 2 on
<Material>
<Byte> Material Range is 0-32
(0 = all materials)
22
(0x16)
Soak Hold 2 off
<Material>
<Byte> Material Range is 0-32
(0 = all materials)
23
(0x17)
Switch
Sensor<Sensor #>
to <Crystal #>
<Byte><Byte> Sensor Range = 1 - 8
Crystal Range = 0 to maximum allowed crystals for the
requested sensor. If Crystal # = 0, will switch to the "next"
crystal. If the sensor is not used in a layer currently
running, the next crystal will be the next one in the
sequence. If the sensor is used in a layer that is running,
the next crystal will be the next one from the XL Position
parameters sequence. If a sensor is used in a layer that
is running, the value of "Crystal #" must be zero,
otherwise, an error will occur.
Table 10-15 Remote general (continued)
RG
Command
ID
Meaning
Action Value Notes