InfoPrint 6500 - Page 248

248
Chapter 7 Fault Messages
051 HAMMER SHORT*
SEE USERS MANUAL
No Hammer driver
circuits on the
controller board
shorted to ground.
Contact your InfoPrint
service representative.
052 MECH DRIVER HOT
SEE USERS MANUAL
No Mechanism driver
temperature is
elevated beyond
normal threshold.
Contact your InfoPrint
service representative.
053 48 VOLTS FAILED*
RECYCLE POWER
No The power supply is
not generating a
proper 48 volts or the
CMX board is not
properly detecting a
48 volt output.
Contact your InfoPrint
service representative.
054 HAMMER COIL SHORT*
SEE USERS MANUAL
No Hammer coil shorted
to ground.
Contact your InfoPrint
service representative.
055 MECH. DRIVER LINK
FAILURE
SEE USERS MANUAL
No Link failure between
the the controller
board and mechanism
driver board.
Contact your InfoPrint
service representative.
056 HAMMER COIL CHECK
SEE USERS MANUAL
No Hammer coil open. Contact your InfoPrint
service representative.
057 CLOSE PLATEN Yes Platen lever is raised
to the open position.
Lower the platen lever.
058 SHUTTLE JAM
SEE USERS MANUAL
No No shuttle movement
or the shuttle is
moving at the wrong
speed.
Make sure the ribbon is not
twisted and the platen lever
is set correctly. If the fault
reoccurs, contact your
InfoPrint service
representative.
059 CANCEL PRINT ACTIVE N/A Non–error status
message.
No action required.
060 PRINTER HOT
SEE USERS MANUAL
No Printer temperature is
elevated beyond
normal threshold.
Contact your InfoPrint
service representative.
Table 9: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution