34 Installation
Anti-intrusion control panels
The following example will help you achieve a correct evaluation:
3-2-2
Installing JOY keypads
1. Remove the keypad from its package.
2. Detach the down-flip and cover from the backplate.
3. Remove the board from the backplate. Be careful not to damage the dislodge-
ment-tamper spring ([A]) during this operation.
4. Mark the chosen anchor-screw locations [B] on the wall. Use at least 2 of the 7
locations available. Drill the anchor-screw holes (ensure that you do not drill in
the vicinity of electrical wiring or plumbing). Pull the BUS and terminal connection
wires through the wire entry [C] and attach the backplate securely to the wall.
5. Using the screw, fasten the dislodgement-tamper bracket into its screw location
[D].
6. For JOY/MAX only: Plug the speaker connector [E] into the keypad circuit, ensure
that polarity is correct (black wire to the right [F] and red wire to the left [G]). Be
careful not to damage the connector during this operation.
If it is necessary to disconnect the connector from the speaker, use a small
screwdriver or similar tool to disengage it by pressing lightly on the part in plas-
tic. DO NOT pull the connector out by the wires.
7. Place the circuit on the two lower supports [H] and, after aligning it with the other
supports [I], push the back-locking grip [J] slightly outwards until it clicks closed.
Be careful not to damage the dislodgement-tamper spring [A].
8. Replace the cover and down-flip. If necessary, secure the two screws into their
screw locations on the bottom part of the cover.
3-2-3
Installing the Aria/HG keypad
1. Choose a suitable mounting location.
2. Put the wall bracket on the selected placement and mark the screw holes (Tabella
2-17: Aria/HG - description of parts, L).
3. Drill the holes.
4. Pull the wires through the cable entry (Tabella 2-17: Aria/HG - description of
parts, M) and wire up the keypad.
5. Using the anchor screws, secure the bracket to the wall.
To Next Page
Loading...
