Installation and programming manual
Installation 35
ATTENTION!
Do not use or remove the counter support on the back of the keypad (Tabella 2-17:
Aria/HG - description of parts, H).
6. Mount the keypad to the wall bracket, by first inserting the locking grips (Tabella
2-17: Aria/HG - description of parts, K) in place, then by pushing the keypad
toward the wall then downward.
7. Fasten the securing screw in place (Tabella 2-17: Aria/HG - description of parts,
J).
3-2-4
Installing nCode/G and
Concept/G keypads
1. Connecting the device to the system
2. Pull the connection wires through the wire entry [A].
3. Connect the cables to the connector on the keypad backplate [B]. If you are using
the connector provided with the KB100 kit [C], connect the wires to the terminals,
in accordance with the instructions described in paragraph 2-3-3 nCode/G and Con-
cept/G Keypads, then insert the connector into the guide [D] until it locks into place.
4. Using at least 2 screws, mount the bracket to the wall.
5. Using the back-locking grips, attach the keypad to the bracket (as shown in figure
[E]).
6. Fasten the screw [F] (included) into the screw location [G], to secure the keypad
properly to the bracket.
3-2-5
Installing Alien/S keypads
1. Connecting the device to the system
2. Pull the connection wires through the wire entry [A].
3. Connect the cables to the connector on the keypad backplate [B].
4. Using the respective anchor holes, mount the bracket to the wall or 503 box.
5. Using the back-locking grips, attach the keypad to the bracket (as shown in figure [C]).
6. Fasten the screw [D] (included) into the screw location [E], to secure the keypad
properly to the bracket.
C
B
D
A
E
F
G
A
B
C
D
E
E
To Next Page
Loading...
