INIM Electronics SmartLiving 10100L - Page 39

Installation and programming manual
Installation 39
3-3-1 Fast addressing of keypads and
readers
If, within 4 seconds of inserting the maintenance jumper (Table 2-8: Mother board -
description of parts, G), you press the open-tamper microswitch on the control panel
cover (Table 2-8: Mother board - description of parts, L), the SmartLiving system will
activate the fast addressing function for the keypads and readers.
All the keypads and readers connected to the I-BUS will be placed in address
programming status and assigned their addresses in sequential order.
At the point, you (the installer) can either change or confirm the assigned addresses.
Note In order to accept this command, the keypad must be 1.12 firmware version or higher.
Table 3-4: Peripherals address
Expansions
address
DIP-switch
12345678
Expansions and
transceivers
address
Red Blue Green Yellow
nBy/S
BS200
nBy/X
Keypads
address
SmartLiving 505 and 515
SmartLiving 505
1 00000000 1 0 0 0 1
1
2 00000001 2 0 0 1 0
3 00000010 3 0 0 1 1
2
4 00000011 4 0 1 0 0
5 00000100 5 0 1 0 1
3
SmartLiving 515
6 00000101 6 0 1 1 0
7 00000110 7 0 1 1 1
4
8 00000111 8 1 0 0 0
9 00001000 9 1 0 0 1
5
10 00001001 10 1 0 1 0
SmartLiving 1050 and 1050L
11 00001010
SmartLiving 1050 and 1050L
11 1 0 1 1
6
12 00001011 12 1 1 0 0
13 00001100 13 1 1 0 1
7
14 00001101 14 1 1 1 0
15 00001110 15 1 1 1 1
8
16 00001111 16 0 0 0 L
17 00010000 17 0 0 L 0
9
18 00010001 18 0 0 L L
19 00010010 19 0 L 0 0
10
20 00010011 20 0 L 0 L
SmartLiving 10100L
21 00010100
SmartLiving 10100L
21 0 L L 0
11
22 00010101 22 0 L L L
23 00010110 23 L 0 0 0
12
24 00010111 24 L 0 0 L
25 00011000 25 L 0 L 0
13
26 00011001 26 L 0 L L
27 00011010 27 L L 0 0
14
28 00011011 28 L L 0 L
29 00011100 29 L L L 0
15
30 00011101 30 L L L L
31 00011110
32 00011111
33 00100000 0 LED Off
34 00100001 1 LED On
35 00100010 L Flashing LED
36 00100011
37 00100100
38 00100101
39 00100110
40 00100111