40 Installation
Anti-intrusion control panels
3-3-2
Addressing the keypads
To assign addresses to keypads, follow the procedure described in paragraph 3-3-1 Fast
addressing of keypads and readers or work through the following steps:
1. Put the control panel in “Maintenance” mode by inserting the respective jumper
(Table 2-8: Mother board - description of parts, G).
2. On the keypad you wish to assign an address to, press and release keys and
simultaneously; set the address then press (if the keypad firmware ver-
sion is 1.02 or higher, go to point 5).
3. (for keypads with built-in reader) enable or disable the reader press key or
.
4. (for keypads with built-in reader) if the reader is enabled, assign the address and
press .
5. If the keypad firmware version is 1.02 or higher, enable or disable the dislodge-
ment tamper protection by pressing or .
6. If the keypad firmware version is 1.08 or higher, enable or disable the dislodge-
ment tamper protection by pressing or .
Note
For security reasons, if the address is not assigned within 30 minutes of accessing “Maintenance”
mode (SERV jumper inserted), the keypad will exit the programming phase automatically.
3-3-3
Addressing the Alien keypad
Work carefully through the following steps.
1. Put the control panel in “Maintenance” mode (paragraph 3-1-9 Maintenance sta-
tus).
2. From the Alien keypad, access the “Settings” section by tapping the , and
then access the “Alien” section. This section provides a list of the keypad param-
eters.
3. Set the parameters:
•PROXY ADDRESS - Alien keypad address
•PROXY ADDRESS - built-in reader address
•ALIEN TAMPER - keypad tamper enablement
4. This parameter can be changed by means of keys + and -.
5. Tap SAVE to set the addresses and exit.
3-3-4
Addressing FLEX5 expansion boards
Using a small screwdriver or similar tool, set the expansion board address on the 8-
segment DIP-Switch strip (Table 2-31: Flex5 - description of parts, C). Each segment
can be set at “1” (On) or “0” (Off).
The figure shows some examples.
The address of the Flex5/DAC board is assigned through the respective programming
menu.
keypad address
_1
Min. 01
Max. 30
To Next Page
Loading...
