<< Back to Contents
Copyright © Innovative Technology Ltd 2018 Doc: NV9 Range User Manual
Version: 1.0
Page 25 of 63
5 SOFTWARE INSTALLATION AND CONFIGURATION
5.1 Introduction
The NV9USB+, NV11+ and NV12+ all leave the factory pre-programmed with
dataset and firmware files. However, it is important to ensure your device is kept up
to date with the latest dataset and firmware. This section will give you a brief
overview of the various update possibilities. For detailed instructions please refer to
the relevant manual package supplied with the software or contact
support@innovative-technology.com.
5.2 Software Downloads
All software from Innovative Technology Ltd is free of charge and can be
downloaded from the website www.innovative-technology.com/support/secure-
download once registered and logged in. If you are not registered, please create an
account via the Create an account form. A confirmation email will be sent to the
registered email address once all contact details have been successfully submitted.
5.3 Drivers
The ITL drivers allow you to connect any of our validators to a compatible Windows
device. If you are connecting via an IF17 then you will not need to follow this
process as they are signed Microsoft Drivers and should install automatically. If this
isn’t the case or your computer is disconnected from the network, there is a
standalone package included within the driver downloads.
5.4 Dataset/Firmware Programming
5.4.1 Validator Manager
5.4.1.1 General Description
Validator Manager is a utility which allows the user to reprogram any of ITL’s
validators. Please note that admin rights are required during installation. The
validator must be in SSP for the Validator Manager to detect the device.
5.4.1.2 System Requirements
• Windows 7 or above
• .Net Framework 4
• 256mb ram
• 50mb hard disk free
• Connected validator with active com port
To Next Page
Loading...
