Innovative Technology NV9 - 9.6 Clearing a Checksum Error; 9.7 Testing after an error has been cleared; 9.8 Re-initialisation of the sensors

<< Back to Contents
Copyright © Innovative Technology Ltd 2018 Doc: NV9 Range User Manual
Version: 1.0
Page 56 of 63
9.6 Clearing a Checksum Error
1. Bezel Flash Code
The flash code will indicate what
type of checksum error the unit
is reporting.
Long
Short
Checksum Type
3
1
Firmware
2
Interface
3
EEPROM
4
Dataset
2. Re-program Unit
This type of error usually occurs
if the file is corrupt or an issue
occurred during download. Retry
download again. If error persists,
please contact support.
9.7 Testing after an error has been cleared
1. Run/test unit
You can use our support tool,
Validator Manager to run the unit
and check operation.
Please refer to our GA02037 - Software
Guide for full instructions on how to use
ITL Validator Manager.
9.8 Re-initialisation of the sensors
1. Calibrate Unit
Use ITL Diagnostics tool, to re-
calibrate the validator, using the
appropriate calibration paper
(LB00149)
Please refer to our GA02037 - Software
Guide for full instructions on how to use
ITL Diagnostics.