<< Back to Contents
Copyright © Innovative Technology Ltd 2018 Doc: NV9 Range User Manual
Version: 1.0
Page 27 of 63
Please note: the connection methods are identical between NV9 and NV11
products.
NV12:
5.4.1.4 Switching to Programming Mode (SSP)
Before programming via Validator Manager, the device needs to be switched to its
programming mode (SSP interface). Please refer to Appendix 11.5 for the procedure
for doing this.
5.4.1.5 Programming the device
Once you have switched the unit into SSP, open Validator Manager and click detect
devices. This will scan all active com ports for a unit, if your validator fails to connect
please ensure the correct drivers are installed and the unit is in SSP.
By selecting the Program tab, you can reprogram the validator. To begin the upload,
click open file, then browse to the file location before clicking OK.
To Next Page
Loading...
