144
SetupSetup
3. Audio Adjust
3. DTS/IMAX
Change the setting of when DTS signals are input.
DTS Auto Surround (Default Value: On)
When inputting DTS signals that include extended channel information, the
optimum listening mode is automatically selected according to the extended
information contained in the input signal and the speaker conguration of this
unit when playing in the straight decoding listening mode.
On When this function is used
O Audio is played using the same amount of channels in the
input signal according to the speaker conguration of this unit.
• If this function is set to "O", the ES Matrix and ES Discrete
listening modes cannot be selected.
Dialog Control (Default Value: 0 dB)
You can increase the volume of dialog portion of the audio up to 6 dB by 1 dB
step so that you can hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not be selected.
IMAX Mode (Default Value: Auto)
Set the IMAX sound mode.
Auto IMAX sound mode is automatically applied when IMAX
content is detected.
On In cases when this unit is unable to recognize IMAX content,
you can apply the IMAX sound mode by turning this setting
"On".
O The setting is disabled.
IMAX User Setting (Default Value: Auto)
When playing IMAX content with the IMAX sound mode, select whether to
automatically apply the speaker setting recommended by IMAX or to set it
manually.
• This cannot be selected when the IMAX Mode is "O".
Auto To use the speaker setup recommended by IMAX.
Manual To manually set "IMAX Bass Feeding" and "IMAX LFE Level".
IMAX Bass Feeding (Default Value: On)
Set the route for the bass component of the audio.
• This cannot be selected when the "IMAX User Setting" is "Auto".
On The bass component of each channel is output according to
the crossover settings ( →p137).
O Only the LFE signal is output.
IMAX LFE Level (Default Value: 0 dB)
• This cannot be selected when the "IMAX User Setting" is "Auto".
You can set the volume for the LFE when IMAX signals are being input. Select
"–∞ dB" or a value between "0 dB" and "-20 dB".
To Next Page
Loading...
Need help?
General
