137
SetupSetup
2. Speaker
2. Crossover
Set what number of Hz in the low frequency range is output from each speaker
and what should be output from the subwoofer. When a subwoofer is not to be
used, set to "Full Band" so that the bass is output from the speakers.
• When Dirac Live Bass Control ( →p174) is used, the crossover frequency
setting made here is not available. Set using Integra Control Pro ( →p173).
Dirac Live Bass Control (Default Value: O)
Use the Dirac Live Bass Control to adjust the crossover frequency.
On When using Dirac Live Bass Control. This can be selected
when Dirac Live Bass Control measurements are performed.
O When this function is to not be used
Crossover Type (Default Value: Normal)
Set the crossover frequency to suit the speakers.
Klipsch When Klipsch speakers are used. The crossover that is
optimum for the speakers selected in Speaker Combo
( →p142) is applied. In this case, the crossover for each
speaker cannot be changed.
Normal When other than Klipsch speakers are used
Front (Default Value: 80 Hz (THX))
Center (Default Value: 80 Hz (THX))
Height 1 (Default Value: 80 Hz (THX))
Height 2 (Default Value: 80 Hz (THX))
Surround (Default Value: 80 Hz (THX))
Surround Back (Default Value: 80 Hz (THX))
LPF of LFE (Default Value: 120 Hz)
Double Bass (Default Value: On)
• As for the THX-certied speakers, the following settings are recommended.
– Crossover frequency → "80 Hz(THX)"
– "LPF of LFE" → "80 Hz"
– "Double Bass" → "O"
• This setting is disabled when the IMAX sound mode has been applied.
However, when the "IMAX User Setting" ( →p144) is "Manual" (default value
is Auto), it is enabled.
Front:
Select the crossover frequency from "40 Hz" to "200 Hz" to start outputting
frequencies for each channel.
"Full Band": Full band will be output.
• If "Conguration" - "Subwoofer Preout" or "Passive Subwoofer" is set to
"No", "Front" is xed to "Full Band", and the low pitched range of the other
channels is output from the front speakers. Refer to the instruction manual of
your speakers to make the setting.
Center, Height 1, Height 2, Surround:
Select the crossover frequency from "40 Hz" to "200 Hz" to start outputting
frequencies for each channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is set to "Full Band".
• If the item cannot be selected even though connection is correct, check if
the setting in "Conguration" - "Speaker Channels" matches the number of
connected channels.
Surround Back:
Select the crossover frequency from "40 Hz" to "200 Hz" to start outputting
frequencies for each channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Surround" is set to "Full Band".
• If the item cannot be selected even though connection is correct, check if
the setting in "Conguration" - "Speaker Channels" matches the number of
connected channels.
LPF of LFE:
Set the low-pass lter for LFE (low-frequency eect) signals in order to pass
only the lower frequency signals than the set value, and thus cancel unwanted
noises. The low-pass lter is eective only on sources with LFE channel.
The value from "80 Hz" to "120 Hz" can be set.
"O": When this function is not used
To Next Page
Loading...
