Integra DRX-8.4 User Manual

157
SetupSetup
6. Hardware
 Network Standby (Default Value: On)
When this function is set to "On", the network function works even in standby
state, and you can turn on the power of the unit via network using an
application such as Integra Control Pro that can control this unit.
• When this function is set to "On", the power consumption in standby state
increases, however, the increase in power consumption is minimized by
automatically entering the Hybrid Standby mode where only the essential
circuits operate. Note that even if this function is set to "O󰀨", when
any of the HDMI CEC ( →p149), HDMI Standby Through ( →p149),
USB Power Out at Standby ( →p156) and Bluetooth Wakeup ( →p157)
functions is enabled, this function will be in "On" state regardless of the
setting.
• When connection to the network is lost, "Network Standby" may be disabled
to reduce power consumption. In such a case, turn the unit on by using the
power button on the remote controller or main unit.
 Bluetooth Wakeup (Default Value: O󰀨)
This function wakes up the unit on standby by connecting a BLUETOOTH
enabled device. This is e󰀨ective when "Bluetooth" - "Bluetooth Receiver" is set
to "On".
On When this function is used
• When this function is set to "On", the power consumption
in standby state increases, however, the increase in power
consumption is minimized by automatically entering the
Hybrid Standby mode where only the essential circuits
operate.
O󰀨 When this function is not used
• This setting is xed to "O󰀨" if "Bluetooth" - "Bluetooth
Receiver" is set to "O󰀨".
• This setting is also xed to "O󰀨" if "Bluetooth" - "Bluetooth
Receiver" - "Auto Input Change" is set to "O󰀨".
• Wait for a while if "Network Standby" and "Bluetooth Wakeup" cannot be
selected. It can be selected when the network function is activated.

Integra DRX-8.4 Specifications

General

Channels	11.2
Amplification Type	Class AB
THD+N	0.08%
HDMI Inputs	7
HDMI 2.1	Yes
HDR Support	HDR10, Dolby Vision, HLG
eARC	Yes
Phono Input	Yes
Zone 2/3 Powered Outputs	Yes
USB Input	1 (Front)
Ethernet	Yes
Wi-Fi	Yes
Bluetooth	Yes
Standby Power Consumption	0.15 W
Power Output (8 Ohms, 20 Hz-20 kHz, 0.08% THD, 2 Channels Driven, FTC)	140W
Power Output (6 Ohms, 1 kHz, 10% THD, 1 Channel Driven)	250 W/Ch
Input Sensitivity and Impedance	200 mV/47 kOhms (Line)
Signal-to-Noise Ratio	106dB
Speaker Impedance	4 Ohms – 16 Ohms
HDMI Outputs	3
Digital Audio Inputs	Optical: 2, Coaxial: 1
Pre-Outs	11.2 Ch
Speaker Terminals	11
Streaming Services	AirPlay 2, Spotify, Tidal, Deezer
Voice Control	Amazon Alexa, Google Assistant
Room Correction	AccuEQ
Supported Audio Formats	Dolby Atmos, DTS:X
Weight	14.5 kg (32 lbs.)