3.2.10.3. Programming .jic files into Serial Flash Device
To program the .jic into the serial flash device through the JTAG interface, perform the following steps:
1. In the Programmer window, click Hardware Setup and select the desired download cable.
2. In the Mode list, select JTAG.
3. Select the device to be programmed and click Add File.
4.
Select the .jic to be programmed to the selected device.
5. Click Start to start programming.
3. Intel Agilex Configuration Schemes
683673 | 2021.10.29
Intel
®
Agilex
™
Configuration User Guide
Send Feedback
122
To Next Page
Loading...
