Intel Agilex Series

Figure 72. Specify the .sof File
SOF Data
Add Bitstream
Input files to convert
Generate
Agilex
9. Click Generate to generate the remote system update programming files. You can now program the flash memory. You
can save the configuration in a .pfg file for later use.
5.5.3. Generating a Factory Update Image
You can generate the factory update image from the command line directly, by running the quartus_pfg with the following
arguments:
quartus_pfg -c fpga.sof factory_update.rpd -o mode=ASX4 -o start_address=<address> -o bitswap=ON -o rsu_upgrade=ON
Note: The rsu1.tcl script that Intel provides performs the bit swap operation. Consequently, if you are using this script, set
bitswap=OFF in the command above.
Alternatively, you can use the Intel Quartus Prime Pro Edition Programming File Generator to generate a factory update
image (.rpd). You can use this image to update the decision firmware, decision firmware data, and the factory image.
1. Note:
The .rpd to program flash memory includes firmware pointer information for image addresses. You must use the
Programming File Generator to generate the .rpd for flash devices.
5. Remote System Update (RSU)
683673 | 2021.10.29
Send Feedback
Intel
®
Agilex
™
Configuration User Guide
189