Using Local User Interface (LUI)
45
8.6 Setting Up Cable and Antenna
This section describes how to setup the antenna.
Setting up the antenna is required before “7.7 Starting Install Menu (Install Wizard)”.
8.6.1 RF Cable Setup
Intellian provides the Antenna RF Cables (LMR400, 5 m) as default. Choose the LMR 400 on the
IF Cable Type and the 5 on the IF Cable Length (m) from the drop-down list. Click on Submit.
NOTE: The RF cable type and length value must be the same as the RF cable being used.
8.6.2 TILT Calibration
Primary
The Tilt Calibration must be applied to both the primary and secondary antennas. Choose the Primary/
Secondary on the Select Antenna and select the Start Calibration on the TILT Calibration Action from
the drop-down list. If you select the Stop on the TILT Calibration Action and Click the Submit, the
antenna system will stop the tilt calibration.
Click on Submit, then click on Next. The antenna system will start the tilt calibration.
To Next Page
Loading...
Need help?
General
