Intermec EasyCoder PD41 User Manual

Chapter 1 — Getting Started
8 EasyCoder PD41 Printer User’s Guide
Installing the Printer
Plugging in the Printer
1 Make sure the Power Switch is turned off.
2 Connect the power cable to the printer.
3 Plug the power cable into your electrical outlet.
Installing the PD41: Stepwise instructions
Fingerprint and IPL
Your PD41 printer is equipped with Fingerprint or IPL
(Intermec Programming Language) firmware. This affects the
functionality of the printer and, to a certain extent, how you
interact with it. In this manual you will come across information
that applies exclusively to either firmware, so it is strongly
recommended that you familiarize yourself enough with your
PD41 to know whether it runs Fingerprint or IPL. The easiest
way to to do is to print a test label (see “Printing a Test Label” on
page 10)
1
2
3

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g