Intermec EasyCoder PD41 User Manual

Appendix D — Setup Parameters (IPL)
86 EasyCoder PD41 Printer User’s Guide
Form Adj Dots X
Specifies where the X-position of the origin should be placed on
the label. Allowed range is -30 (closest to the leading edge) to 30
(furthest from the leading edge). Default is 0.
Form Adj Dots Y
Specifies where the Y-position of the origin should be placed on
the label. Allowed range is -30 (closest to the center section) to 30
(furthest from the center section). Default is 0.
Configuration Setup
Emulation
Emulation mode lets you print bar code labels that were
originally designed on an 86XX printer in multiples of 10 or 15
mil. When the printer is working in emulation mode, not all IPL
commands are supported. For a complete list of commands
available during emulation mode, see the the IPL Programmer’s
Reference Manual.
Default emulation mode is “none”.
Print Speed
You can select the print speed from 2 in./sec. (50 mm/sec.) to 6
in./sec.(100 mm/sec.) with an interval of 1 in./sec. The higher
the print speed, the more wear on the printhead, so do not use a
higher print speed than necessary. For some direct thermal media
or ribbon/media combinations, setting the highest print speed
may reduce print quality significantly.
Cutter (option)
Once a cutter has been installed in the printer, it must also be
enabled in the firmware. IPL commands are used to enable/
disable the cutter in configuration mode:
<STX>R<ETX> Enter print/configuration mode
<STX>SIc1<ETX> Enable cutter
<STX>SIc0<ETX> Disable cutter
Label Taken Sensor
To make the printer work in Peel off (self-strip) mode, that is,
waiting for a label to be removed before the next label is printed,
the self-strip mode must be enabled. This can be done by
executing the following commands:

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g