Intermec EasyCoder PD41 User Manual

Appendix C — Setup Parameters (Fingerprint)
EasyCoder PD41 Printer User’s Guide 71
• 115200
Character Length
The character length specifies the number of bits that will define
a character. Eight bits are recommended, since that option allows
more special characters and characters that are used exclusively in
foreign languages. Refer to the Intermec Fingerprint v10.X.X,
Programmer’s Reference Manual for more information.
• 7 (Characters ASCII 000 to 127 decimal)
• 8 (Characters ASCII 000 to 255 decimal). Default.
Parity
The parity decides how the firmware will check for transmission
errors. There are five options:
• None (default)
•Even
•Odd
•Mark
•Space
Stop Bits
The number of stop bits specifies how many bits will define the
end of a character. There are two options:
•1 (default)
•2
Flow Control
RTS/CTS is a protocol in which communication is controlled
via currents through separate lines in a cable that are set either to
HIGH or LOW. By default, this option is disabled.
CTS on the Printer is connected to RTS on the PC and vice
versa. CTS HIGH from the printer indicates that the unit is
ready to receive data.
CTS LOW from the printer indicated that the receive buffer is
full (see XON/XOFF). In some computer programs, e.g.
Microsoft Windows HyperTerminal, RTS/CTS is designated
"Hardware."

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g