Appendix C — Setup Parameters (Fingerprint)
EasyCoder PD41 Printer User’s Guide 73
origin is moved further back from the forward edge of the
copy.
• A negative start adjustment means that the specified length of
media will be pulled back before the printing starts. Thus, the
origin is moved towards the forward edge of the copy.
Stop Adjust
The Stop Adjust value is given as a positive or negative number of
dots. Default value is 0, which stops the media feed in a position
suitable for tear off operation.
• A positive stop adjustment means that the normal media feed
after the printing is completed will be increased by the
specified value.
• A negative stop adjustment means that the normal media feed
after the printing is completed will be decreased by the
specified value.
Media Setup
The media parameters tell the firmware the characteristics of the
media that will be used, so that the printout will be positioned
correctly and attain the highest possible quality.
Media Size
The size of the printable area is defined by three parameters; X-
Start, Width, and Length.
X-Start
Specifies the position of the origin along the dots on the
printhead.
The default X-start value prevents printing outside the labels
when the liner is slightly wider than the labels. If you want to
maximize the print width, reset the X-start value to its default: 0.
By increasing the value for the X-start parameter, the origin will
be moved outwards, away from the inner edge of the media path.
In other words, the larger X-start value, the wider inner margin
and the less available print width.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
