Intermec EasyCoder PD41 User Manual

Appendix C — Setup Parameters (Fingerprint)
70 EasyCoder PD41 Printer User’s Guide
Setup Description
The printer’s Setup parameters are used to set the printer’s
operational behavior. Chapter 5, “Configuring Settings”,
explains how to set or change the parameters, and this is also
explained in the Fingerprint v10.X.X Programmer’s Reference
Manual, under the
SETUP command.
Serial Communication Setup
The serial communication parameters control the
communication between the printer and the connected computer
or other devices on the standard serial port, referred to as
"uart1:".
For the serial communication channel ("uart1:"), the following
parameters can be set. Make sure they match the setup of the
connected device or vice versa. If the setup of the printer and the
setup of the host do not match, the response from the printer to
host will be garbled.
Baud Rate
The baud rate is the transmission speed in bits per second. There
are 10 options:
•300
•600
•1200
•2400
•4800
• 9600 (default)
• 19200
• 38400
• 57600
Note: The recommended way to set your printer’s
configuration parameters is to use the PrintSet 4
program, which is included on the PrinterCompanion
CD. PrintSet 4 can communicate with your printer
either via a serial cable or a network connection.

Intermec EasyCoder PD41 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power requirements	100-240 VAC ±10%, 45-65 Hz
Media thickness	2.3 - 9.8 mm
Maximum label width	104 mm
Maximum label length	0.15 m
Maximum roll diameter	213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 85 %

Weight and Dimensions

Depth	453 mm
Width	273 mm
Height	270 mm
Weight	13000 g