Chapter 2 — Configuring Network Settings
26 IF61 Fixed Reader User’s Manual
Enable DHCP Check this check box if you want the IF61 to
get its wireless IP address from a DHCP
server. DHCP is enabled by default.
If this check box is not checked, DHCP is
disabled and you need to specify the IP
address, subnet mask, and IP router for your
network.
IP Address IP address for the 802.11 radio. The IP
address has the form x.x.x.x, where x is a
number from 0 to 255.
If DHCP is enabled, the currently assigned
IP address appears in this field.
If DHCP is disabled, set this value to a static
IP address for the 802.11g radio.
Subnet Mask Subnet mask that matches the other devices
in your network. The subnet mask has the
form x.x.x.x, where x is a number from 0 to
255.
Router (Gateway) IP address of the router that will forward
frames if the IF61 will communicate with
devices on another subnet. The IP address
has the form x.x.x.x, where x is a number
from 0 to 255.
IPv6 Autoconfigure Enables IPv6 automatic configuration for
the radio. Uncheck this check box to disable
IPv6 auto-configuration on the IF61.
Auto-configuration is enabled by default. If
you disable auto-configuration, you need to
specify an IPv6 address, subnet mask, and
router.
IPv6 Address 128-bit IPv6 address for the IF61.
IPv6 Subnet Mask 1 to 128-bit IPv6 subnet mask.
IPv6 Router (Gateway) 128-bit address for the IPv6 router.
802.11 Radio Settings Descriptions (continued)
Setting Description
To Next Page
Loading...
