INVT Goodrive350 IP55

Goodrive350 IP55 High-ingress Protection Series VFD Expansion cards
-325-
Indicator
Name
Function
the expansion card is properly connected to the control board
(the period is 1s, on for 0.5s, and off for the other 0.5s); and it
is off when the expansion card is disconnected from the
control board.
LED2
Disconnection
indicator
When the encoder is rotating, this indicator blinks when A1 or
B1 of the encoder are disconnected; otherwise it is always on.
LED3
Power indicator
This indicator is on after the control board feeds power to the
PG card.
The EC-PG505-12 expansion card can be used in combination with multiple types of
incremental encoders through different modes of wiring. It is user-friendly, adopting spring
terminals.
EC-PG505-12 terminal function description
Label
Name
Function description
PWR
Encoder power
Voltage: 5 V/12 V ±5%
Max. output: 150 mA
Select the voltage class through the DIP switch SW1 based
on the voltage class of the used encoder. (PGND is
isolation power ground)
PGND
A1+
Encoder interface
1. Supporting push-pull interfaces of 5 V/12 V
2. Supporting open collector interfaces of 5 V/12 V
3. Supporting differential interfaces of 5 V
4. Response frequency: 200 kHz
A1-
B1+
B1-
Z1+
Z1-
A2+
Pulse setting
1. Supporting the same signal types as the encoder signal
types
2. Response frequency: 200 kHz
A2-
B2+
B2-
Z2+
Z2-
AO+
Frequency-divided
output
1. Differential output of 5 V
2. Supporting frequency division of 1–255, which can be set
through P20.16 or P24.16
AO-
BO+
BO-
ZO+
ZO-