Wireless Access Point
User Guide
---End
Parameter description
Parameter Description
SSID
It specifies the SSID to be configured.
The AP supports four SSIDs and the first SSID displayed is the primary SSID.
Enable
It specifies whether to enable the selected SSID.
The AP supports four SSIDs being enabled concurrently, and the primary SSID is
enabled by default, while the other are disabled. Users can enable them if required.
Broadcast SSID
It specifies whether to broadcast the selected SSID.
−
Enable: It indicates that the AP broadcasts the selected SSID. In this case,
nearby wireless devices can detect the SSID.
−
Disable: It indicates that the AP does not broadcast the selected SSID so that
nearby wireless devices cannot detect the SSID. In this case, if you want to
connect a wireless device to the WiFi network corresponding to the SSID, you
must enter the SSID on the device manually.
This AP can hide its SSID automatically. When the number of devices connected
to the AP to an SSID of the AP reaches the upper limit, the AP stops broadcasting
To Next Page
Loading...
