IRIS IRMA MATRIX 2

5
/74
IRMA
MATRIX R2 CAN Installation manual
released
Rev. 1.6
2018-09
12.3.2 Installations with sCON-F-12 ................................................................................................... 68
12.3.3 Installation with second power supply in articulated bus (with sCON-S) ................... 68
13 Annex B Drilling patterns .......................................................................................... 74
Table of illustrations
Fig. 1: Comparison - DHCP deactivated in old counting firmware ............................ 11
Fig. 2: Comparison - deactivated buttons under "Installation" .................................. 11
Fig. 3: Example of installation conditions in the upper part of the door trim ........ 12
Fig. 4: Maximum distance to the end of vehicle inside wall ....................................... 14
Fig. 5: Label on the rear - Observe mounting orientation!........................................... 15
Fig. 6: Determination of the center of the clear passage width ................................. 15
Fig. 7: Mounting of the surface mount version .............................................................. 18
Fig. 8: sCON-S (standard) - overview of the connection components ..................... 19
Fig. 9: Mounting with mounting set and sCON-S (standard) - overview ................. 20
Fig. 10: Setting, adjusting and tightening of the cylinder head screws ..................... 21
Fig. 11: Pushing the spring holders in place and screwing them tight ....................... 21
Fig. 12: Connector version sCON-F-12 w/ Surface mount version sensor ................. 22
Fig. 13: Mounting with sCON-F-12 – overview ................................................................. 23
Fig. 14: sCON-F-12 - positioning and adjustment ............................................................ 24
Fig. 15: Selection of the number of IRMA MATRIX sensors ........................................... 26
Fig. 16: Central installation position – 1 IRMA MATRIX sensor ..................................... 26
Fig. 17: Distance (X) of two sensors depending on the door height ............................ 27
Fig. 18: 2 IRMA MATRIX sensors per door (X = sensor distance) ................................... 28
Fig. 19: sCON-S (standard): Threaded hole for attaching the grounding cable ........ 30
Fig. 20: sCON-F-12: threaded holes for connecting the grounding cable .................. 31
Fig. 21: Mounting holes for attaching the grounding cable .......................................... 31
Fig. 22: Power supply, sensor with fuse and timing relay for 30 minutes of after-run
power ............................................................................................................................. 34
Fig. 23: Connection of the CAN-USB converter to H couplers ....................................... 43
Fig. 24: Opening of the BUS with H coupler for connection of the CAN-USB
converter ....................................................................................................................... 44
Fig. 25: PC connection via sCON-S (standard) with additional Ethernet interface .. 45
Fig. 26: Service connection to an installation with sCON-F-12 ..................................... 46
Fig. 27: Version of the service software program - Menu point "?" - please check! 47
Fig. 28: Sensor selection and firmware ............................................................................... 47
Fig. 29: DHCP option in the tab „Ethernet“ ........................................................................ 48