/74
MATRIX R2 CAN Installation manual
Fig. 30: "Installation" / representation "Function Area Address" on the vehicle ...... 49
Fig. 31: Installation parameters section - Parameters in the door area at a glance 50
Fig. 32: Sector “Function area/door” - FA on product label (framed in yellow) ........ 50
Fig. 33: Sector “Mounting Height”........................................................................................ 51
Fig. 34: Sector “Wall Distance (Left, Right)” ....................................................................... 52
Fig. 35: Sector "Door To Sensor Distance" ........................................................................... 52
Fig. 36: Sector "Vehicle Edge Offset" .................................................................................... 53
Fig. 37: Sector "Rotation Angle X" ......................................................................................... 53
Fig. 38: Sector "Door Clearance (Left, Right)" ..................................................................... 54
Fig. 39: Sector "Door Opening Angle (Left, Right)"............................................................ 54
Fig. 40: On the left: start the "A21_Assistent" software / on the right: splash
screen of "A21_Assistent" ........................................................................................ 56
Fig. 41: Configuration menu for IRMA gateway ............................................................... 57
Fig. 42: Flowchart (protocol variants: IBIS, IRMA (UIP), J1708) ..................................... 60
Fig. 43: Flowchart for checking the counting operation ................................................. 61
Fig. 44: Sensor installation in a 3-door vehicle with sCON-S (standard) for
CAN - IRMA gateway at the beginning (M12 connector) ................................. 69
Fig. 45: Sensor installation in a 4-door vehicle with sCON-S (standard) for
CAN - IRMA gateway in the center (M12 connector) ........................................ 70
Fig. 46: Sensor installation in a 3-door vehicle with sCON-F-12 - IRMA gateway
at the beginning (M12 connector) ......................................................................... 71
Fig. 47: Sensor installation in a 4-door vehicle with sCON-F-12 - IRMA gateway
in the center (M12 connector) ................................................................................ 72
Fig. 48: CAN installation in a 4-door articulated vehicle (direct connection to the
on-board computer, second power supply on the CAN BUS) ......................... 73
To Next Page
Loading...
