Chapter 2 Functions for Each Mode
OTHER FILM LENGTH: Adjusts the film cut length.
L/R FOLDERS: Adjusts the movement (squeezing amount) of the left and
right squeezing plates.
<> buttons: Squeeze outside, >< buttons: Squeeze
inside
5. Touching the [ADJUST2] tab displays the [TRAY(ADJUST2)] screen.
You can fine-adjust the tray information setting than in the [TRAY(ADJUST1)] screen.
The [TRAY(ADJUST2)] screen is provided specifically for the manufacturer. Incorrect setting may cause
damage of the product or commodities. Do not change the setting unless you are qualified to do so. To
display the [TRAY(ADJUST2)] screen, the password is required.
FRONT CLAMP Adjusts the film tension with the front clamp. The larger the clamping time
(larger + value), the larger the film tension becomes. The smaller (larger -
value), the smaller the tension becomes.
REAR CLAMP Adjusts the film tension with the back clamp. The larger the clamping time
(larger + value), the larger the film tension becomes. The smaller (larger -
value), the smaller the tension becomes.
FILM CENTER ON: Adjusts the feeding film stop position.
LENGTH: Adjusts the film cut length.
L/R FOLDERS ON Adjusts the timing of the left and right squeezing plates to start moving.
F button: Earlier, D button: Later
2-13
To Next Page
Loading...