PAMSPAN501x G.SHDSL.bis EFM Gateway
-86
6. Config Pvid Status is non-configurable and is always true, i.e. the Ethernet Bridge
supports the ability to override the default PVID setting and its egress status (VLAN
tagged or untagged) on each Ethernet Bridge interface.
7. Tagging is non-configurable and is always enabled, i.e. each Ethernet Bridge
interface supports 802.1Q VLAN tagging of frames.
8. AcceptableFrameTypeCfg is non-configurable and is always enabled, i.e. each
Ethernet Bridge interface can be configured to accept all frames or only tagged frames.
9. IngressFilteringCfg is non-configurable and is always enabled, i.e. each Ethernet
Bridge interface supports discarding of frames whose VLAN classification does not
include that interface in its member set.
10. Filter Age (in seconds) sets the duration after which MAC addresses are removed
from the filter table when there has been no activity. The time may be an integer value
between 10 and 100,000 seconds. The default value is 300 seconds. To change the
filter age value, enter the required number of seconds in the filter age field, and then
click to save the settings.
11. Traffic Class Mapping. To set the traffic class, select an option from the
drop-down list and click to save the settings. The following table gives the
range of values for each option that can be specified with this command, and a default
value.
Option Description Default value
enable Enables the mapping of each regenerated
priority to its traffic class.
Disabled
disable Disables the mapping of each regenerated
priority to its traffic class.
Disabled
prioritybased
Traffic class mapping will only occur if the
traffic class has not already been set.
Disabled
12. Filter Unknown VLAN. Filters out unknown VLAN frames. The default value is set
to enabled. To disable the filter, select an option from the drop-down list and choose
Disabled. Then click to save the settings. You can also use CLI to
configure the unknown VLAN filter settings.
#> unknownVlanFilter (How to handle unknown VLAN frames)
Enabled: Drop Unknown VLAN frames (Default action)
Disabled: Pass Unknown VLAN frames based on Default VLAN ports.
To Next Page
Loading...