PAMSPAN501x G.SHDSL.bis EFM Gateway
-53
3.2.3.6.1 Command Line Interface for DNS Relay
You can also use the command line interface (CLI) to configure the DNS relay.
Below are some examples:
To allow the DHCP to pass DNS server information to the DNS relay, enter:
#> dhcpclient set interfaceconfig WAN givetodnsrelay enabled
To set a DNS server that the DNS relay can use to obtain domain/address
information, enter:
#> dnsrelay add server <ip-address>
The DNS server address should be supplied by your ISP. To display servers,
enter:
#> dnsrelay list servers
3.2.3.7 SNTP Client
This option allows you to:
• Synchronize a Client with an NTP Server
• Configure the SNTP-NTP Server
•
Manually set the system clock
Click on SNTP client from the Configuration menu. The following page will be
displayed:
To Next Page
Loading...