ITech IT-M7700 Series - Page 125

Programming Examples
Copyright© Itech Electronic Co., Ltd. 113
-> LIST:RECOrder? 1
-> LIST:RECOrder? 2
-> LIST:RECOrder? 3
-> LIST:RECOrder? 4
-> LIST:RECOrder? 5
-> LIST:STATe 0
Run/Stop List
The user can run the existed list program as needed to enable outputting of
corresponding waveform sequence by the power supply. Detailed operation
steps are as below:
Please enter the following command:
-> SYSTem:REMote
-> LIST:STATe 1
-> LIST:RUN
-> LIST:STOP