UMG 804 www.janitza.com
16
6. Features and Monitored Parameters
6.1 Features
Feature / Version
Standard
(v1.048 or lower)
Enhanced
(v1.126 or higher)
Supports 96 circuits using up to four interface cards
• •
Dual Ethernet ports
• •
Integrated webserver
Original version •
Remote and local firmware upgrade
Local upload only •
Network accessible configuration
• •
Modbus TCP/IP and RTU output
• •
Smart breaker trip detection
• •
True circuit display • •
Alarming Latching only •
HTML interface • •
Lock device settings CT size only •
Waveform capture on an event per channel • •
BACnet interface Basic function only •
Sag/Swell detection and logging •
Virtual meters •
Potential transformer scaling •
REST API interface •
SNMP v2 interface •
CBEMA / ITIC compliance monitoring •
· Supports 96 circuits using up to four
interface cards:
each of the four Smart Ports can host a CT inter-
face card with 24 circuits.
· Dual Ethernet ports:
two Ethernet ports allow for easy daisy chaining
of communications connections to avoid costly
dedicated wiring runs to switches.
· Integrated web server:
access real time data and perform configuration
using a standard internet browser; no software
required.
· Remote and local firmware upgrade:
upgrade firmware easily using a USB flash drive
locally or over the network
· Network accessible configuration:
configure the monitor over the network or using
the configuration table with easy auto-upload
using a USB flash drive.
· Modbus TCP/IP and RTU output:
supports Modbus TCP/IP or Modbus RTU serial
communications.
· Smart breaker trip detection:
can detect fast drops in current to alert to poten-
tial open circuits/breaker trips.
· True circuit display:
allows two and three-phase circuits to be grou-
ped to provide an average output for the circuit as
well as derived neutral.
To Next Page
