Section 1 - General Information
Introduction
Identifying your Machine
1-5 1-5
9803/9340-8
Tier 3 Typical Engine Identification
Number
The engine data label is located on the cylinder block at
position A. K Fig 10. ( T 1-5). The data label includes the
engine identification number.
A typical engine identification number is explained as
follows:
1 Engine Type
GJ = Naturally aspirated (Tier 3)
2 Build Number
3 Country of manufacture
U = United Kingdom
4 Engine Serial Number
5 Year of Manufacture
T017650-1
Fig 10.
ROPS and FOPS
!M
WARNING
You could be killed or seriously injured if you operate
a machine with a damaged or missing ROPS/FOPS. If
the Roll Over Protection Structure (ROPS)/Falling
Objects Protection Structure (FOPS) has been in an
accident, do not use the machine until the structure
has been renewed. Modifications and repairs that are
not approved by the manufacturer may be dangerous
and will invalidate the
ROPS/FOPS certification.
INT-2-1-9_6
Machines built to ROPS and FOPS standards have an
identification label fitted the canopy. K Fig 11. ( T 1-5).
Fig 11.
!M
WARNING
Seat Belts
The ROPS/FOPS is designed to give you protection in
an accident. If you do not wear your seat belt, you
could be thrown out of the machine and crushed. You
must wear a seat belt when using the machine. Fasten
the seat belt before starting the engine.
0153
GJ 65693 U 500405 P
1 2 3 4 5
To Next Page
Loading...
